Honsberg LABO-F012-S100KPH0H in JAPAN

Get the best sales prices in JAPAN for Honsberg LABO-F012-S100KPH0H from Yusaki LLC.

Yusaki LLC is here to help you with procurement of LABO-F012-S100KPH0H Flow switch and other products and spare parts of Honsberg.

Our team of experts will find the best sales prices for Honsberg - LABO-F012-S100KPH0H Flow switch in Japan.

The products of Honsberg are leading in this area. High quality with reasonable price.Our services will save you time and money which on the other side will help you growth your business!We are not a distributor of Honsberg but we can sell their products to you on good prices.Buy the original product of Honsberg - LABO-F012-S100KPH0H Flow switch in Japan at reasonable price.During the past years we managed to develop enough to satisfy the requirements of our customers.Send us your inquiry by e-mail or fill out our online contact form.

Characteristics :
The sensors of the LABO-F012 family are used for monitoring
non-viscous fluids (for oil or gases on request). They come
complete with electronics, and are supplied installed inside a
compact sensor housing of 12 mm diameter and with M12x1 round
plug outlet. The 16-bit processor carries out temperature
compensation and linearisation of the calorimetric signal
(measurement of the heat removal at the sensor tip by the flowing
medium; for this see also the general description for calorimetry).
The electronics of the LABO-F012-S are a flexibly configurable limit
switch.
The switching value can be set by the user via teaching (see
Handling and Operation). All other values have been preset at the
factory, but can be modified by the user with the aid of the
optionally available ECI-1 interface and a PC.
The adjustable parameters are:
● Switching value
● Hysteresis
● Minimum/maximum monitoring
● Switching delay
● Switchback delay
● Power-On delay
● Teach-offset

 

Technical data :

Sensor : Calorimetric measurement principle
Process connection : push-in sensor Ø12 mm
Switching range water :  2..150 cm/s or 3..300 cm/s oil or gases available on request
Measurement accuracy : dependent on the installation location and flow conditions typically ±10 % of full scale value or 2 cm/s, of full scale value measured in the T-piece ±5 %
Repeatability : ±1 %
Start-up time : 10 sec. after application of the operating voltage
Response :  time 1..3 s
Pressure resistance Stainless steel compression fitting PN 40 bar
Plastic cone with union nut PN 10 bar
Medium temperature : -20..+ 70 °C -20..+100 °C (extended temperature range)
Ambient temperature : 0..+60 °C
Temperature dependency : ± 0.01 % / 1 K
Temperature gradient : 4 K/s
Materials medium-contact : Housing 1.4571
Materials nonmedium-contact : Plug PA6.6 gold-plated contacts
Supply voltage :  24 V DC ±10 % (controlled)
Power consumption : < 2 W
LED : yellow LED (On = Normal / Off = Alarm / rapid flashing = Programming)
Electrical connection : for round plug connector M12x1, 4-pole
Ingress protection : IP 67
Weight approx. : 0.05 kg

LABO-F012-S100KPH0H.pdf

Other products from Honsberg